Ametek PLA-PLW Programming Manual Manual de usuario descargar pdf (Pagina 62)

[SOURce:]VOLTage[:TRANsient]:TWIDth

This command sets the pulse width of the transients when the generator is in PULSe mode.

Command Syntax VOLTage:TRANsient:TWIDth <NRf+>

VOLTage:TWIDth <NRf+>

Parameters pulse width value, refer to model’s specification | MAX | MIN

Unit ms

Query Syntax VOLTage:TRANsient:TWIDth?

VOLTage:TWIDth?

Returned Parameters <NRf+> a integer representing pulse width value

Under Voltage Lockout Protection

The programmable under voltage lockout feature allows the user to set the trip point between zero and

full-scale voltage. The input will remain off until the input voltage is greater than the pre-programmed

value.

Continuous Mode

When the V-On is set to continuous mode, the UVL message will appear and the input current will be

forced off each time the voltage drops below the set threshold voltage.

Input-On Mode

Under “input on” mode, the UVL will detect under voltage only once, and will reset each time the

input is turned off. When the voltage is below the UVL threshold, the input current will be forced off

and an “UVL” message will display.

By default, the V-On threshold is set to 1 V and the V-On feature can also prevent turn-on current

spike from occurring. As a precaution, it is recommended to leave the V-On threshold at 1 V or

higher.

˖̂̀̀˴́˷ˍʳ

Use " VOLT:VON <value> " to set value.

Use "VOLT:VON:STAT 0 | 1" to set VON mode. 0 - only work when input ON, 1 - continue

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 73 74

Sin comentarios

Ametek PLA-PLW Programming Manual Manual de usuario Pagina 62