Ametek PLA-PLW Programming Manual Manual de usuario descargar pdf (Pagina 22)

slew time value may be entered, the electronic load selects a slew time that is closest to the

programmed value. MINimum sets the slew to the fastest possible time. MAXimum sets the slew to

the slowest time.

Note: Slew time greater than the maximum value is set to MAXimum. Slew time less than the

minimum value are set to MINimum.

Command Syntax CURRent:SLEW:BOTH <NRf+>

Parameters Slew time. Refer to model specifications | MIN | MAX

Unit ms

Query

Syntax None

[SOURce:]CURRent:SLEW:NEGative

This command sets the slew time of the current for negative going transitions. MINimum sets the slew

to the fastest possible time. MAXimum sets the slew to the slowest time.

Note: Slew time greater than the maximum value is set to MAXimum. Slew time less than the

minimum value are set to MINimum.

Command Syntax CURRent:SLEW:NEGative <NRf+>

Parameters Slew time. Refer to model speci

fications | MIN | MAX

Unit ms

Query Syntax CURRent:SLEW:NEGative?

CURRent:SLEW:NEGative? MIN

CURRent:SLEW:NEGative? MAX

Returned Parameters <NRf+>, slew time.

[SOURce:]CURRent:SLEW[:POSitive]

This command sets the slew time of the current for positive going transitions. MINimum sets the slew

to the fastest possible time. MAXimum sets the slew to the slowest time.

Note: Slew time greater than the maximum value is set to MAXimum. Slew time less than the

minimum value are set to MINimum.

Command Syntax CURRent:SLEW <NRf+>

CURRent:SLEW:POSitive <NRf+>

Parameters <NRf+>: slew time. Re

fer to model specifications | MIN | MAX

Unit ms

Query Syntax CURRent:SLEW?

CURRent:SLEW? MIN CURRent:SLEW? MAX

CURRent:SLEW:POSitive?

CURRent:SLEW:POSitive? MIN

CURRent:SLEW:POSitive? MAX

Returned Parameters <NRf+>, slew time

[SOURce:]CURRent:TLEVel, ITR

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 73 74

Sin comentarios

Ametek PLA-PLW Programming Manual Manual de usuario Pagina 22