Ametek PLA-PLW Programming Manual Manual de usuario descargar pdf (Pagina 30)

MEASUREMENT COMMANDS

MEASure:CURRent[:DC]?

MEASure:POWer[:DC]?

MEASure:RESistance[:DC]?

MEASure:VOLTage[:DC]?

MEASure:VOLTage:INPut?

This function consists of queries that return the current, power, resistance ,and voltage at the

input of the electronic load.

Query Syntax

MEASure:CURRent? electronic load input current

MEASure:POWer? Computed electronic load input power

MEASure:RESistance? Computed electronic load input resiatance

MEASure:VOLTage? electronic load input voltage

MEASure:VOLT:INPut? electronic load input voltage at input end

Returned parameters <NRf+> Value representing amperes, watts, ohm, or volts

MEASure:DELay

This command is to sets or queries the delay time to obtain read back value for “MEAS:CURR?”,

“MEAS:POW?”, “MEAS:RES?” and “MEAS:VOLT?” queries.

Command Syntax MEASure:DELay <NR1>

Parameters 0 t0 2000 | MIN | MAX

Unit milli-second

Query Syntax MEASure:DELay?

MEASure:DELay? MIN MEASure:DELay? MAX

Returned Parameters <NR1> delay time in ms

MEASure:SENSe

This command sets or queries the measurement sense (Local / Remote ).

Note: When input voltage is greater than 30 V, this command will cause an execution error.

Command Syntax MEASure:SENSe <bool>

Parameters 0 | 1 | LOCal(0) | REMote(1)

Query Syntax MEASure:SENSe?

Returned Parameters <bool> 0=LOCal

1=REMote

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 73 74

Sin comentarios

Ametek PLA-PLW Programming Manual Manual de usuario Pagina 30