Ametek PLA-PLW Programming Manual Manual de usuario descargar pdf (Pagina 57)

UTILITY COMMANDS

UTILity:RANGe

This command selects and queries the range control mode.

Command Syntax UTILity:RANGe <bool>

Parameters <bool> range control mode.

0 : manual mode,

1 : auto mode,

Query Syntax UTILity:RANGe?

Returned Parameters <NR1> integer representing range control mode

UTILity:MEASure:SENSe

This command sets or queries the measurement sense (Local / Remote ).

Note: When input voltage is greater than 30 V, this command will cause an execution error.

Command Syntax UTILity:MEASure:SENSe <bool>

Parameters 0 | 1 | LOCal(0) | REMote(1)

Query Syntax UTILity:MEASure:SENSe?

Returned Parameters <bool> 0=LOCal

1=REMote

UTILity:TR:MODE

UTILity:TRANsient:MODE

This command selects the operating mode of the transient generator as follows.

TRIGger The transient switch to trigger levels upon receipt of a trigger.

CONTinuous The transient generator puts out a continuous pulse stream.

TOGGle The transient generator toggles between two levels upon receipt of a

trigger.

PULSe The transient generator puts out a single pulse upon receipt of a trigger.

Command Syntax TR:MODe <NR1>

TRANsient:MODe <NR1>

Parameters <NR1> transient mode

0:TRIGger

1:CONTinuous

2:TOGGle

3:PULSe

4:STEP

5:AUTO

6:ONCE

Query Syntax TR:MODe?

TRANsient:MODe?

Returned Parameters <NR1> integer value representing transient mode

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 73 74

Sin comentarios

Ametek PLA-PLW Programming Manual Manual de usuario Pagina 57