Ametek PLA-PLW Programming Manual Manual de usuario descargar pdf (Pagina 54)

TRANSIENT COMMANDS

These commands program the transient generator of the electronic load. The transient

generator programs a second (transient) level at which the electronic load can operate

without changing the original programmed settings.

See also [SOURce:]CURRent:TLEVel, [SOURce:]RESistance:TLEVel, and

[SOURce:]VOLTage:TLEVel in the Input Commands section.

[SOURce:]TRANsient

This command turns the transient generator on or off.

Command Syntax TRANsient <bool>

Parameters 0 | 1 | OFF | ON

*RST Value OFF

Query Syntax TRANsient?

Returned Parameters <NR3>

[SOURce:]TR:MODe

[SOURce:]TRANsient:MODe

This command selects the operating mode of the transient generator as follows.

TRIGger The transient switch to trigger levels upon receipt of a trigger.

CONTinuous The transient generator puts out a continuous pulse stream.

TOGGle The transient generator toggles between two levels upon receipt of a

trigger.

PULSe The transient generator puts out a single pulse upon receipt of a trigger.

Command Syntax TR:MODe <NR1>

TRANsient:MODe <NR1>

Parameters <NR1> transient mode

0:TRIGger

1:CONTinuous

2:TOGGle

3:PULSe

4:STEP

5:AUTO

6:ONCE

Query

Syntax TR:MODe?

TRANsient:MODe?

Returned Parameters <NR1> integer value representing transient mode

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 73 74

Sin comentarios

Ametek PLA-PLW Programming Manual Manual de usuario Pagina 54