Ametek PLA-PLW Programming Manual Manual de usuario descargar pdf (Pagina 27)

[SOURce:]STEP:POWer:STATe

This command specifies how to process the STEP sequencing. The following parameters may be

specified.

ON Causes the entire STEP to be executed immediately, paced by its dwell delays. As

each dwell delay elapses, the next point is immediately executed.

ONCE Causes the STEP to advance only one point after each trigger. Triggers that arrive

during a dwell delay are ignored

AUTO Causes the entire STEP to be executed sequentially after the starting trigger, paced

by its dwell delays. As each dwell delay elapses, the next point is immediately executed.

Command Syntax STEP:POWer:STATe <NR1>

Parameters 0 | OFF(0) | 1 | ON(1) | 2 | AUTO(2) | 3 | ONCE(3)

*RST Value 0

Query Syntax STEP:POWer:STATe?

Returned Parameters <NR1> 0=OFF

1=ON

2=AUTO

3=ONCE

[SOURce:]STEP:RESistance[:LEVel]

This command specifies the resistance setting for each STEP step.

Command Syntax STEP:RESistance <NR1>,<NRf+>

Parameters <NR1> point index, 1 through 32

<NRf+> resistance level value, refer individual model specification for

range. | MIN | MAX

Query Syntax STEP:RESistance? <NR1>

Parameters <NR1> point index

Returned Parameters <NRf+> resistance value

[SOURce:]STEP:RESistance:TIMe?

This command specifies the dwell time for each STEP step. Each value of point represents the time in

milli-seconds that the input will remain at the particular STEP step point before completing the step. At

the end of the dwell time, the input of the electronic load depends upon the following conditions:

If STEP:RESistance:STATe AUTO has been programmed, the input automatically

changes to the next point in the STEP.

If STEP:RESistance:STATe ONCE has been programmed, the input remains at the

present level until a trigger sequences the next point in the STEP.

Command Syntax STEP:RESistance:TIMe <NR1>,<NR1>

Parameters 1

<NR1> point index

<NR1> 0 to 65535 | MIN | MAX

Unit ms

Query Syntax STEP:RESistance:TIMe? <NR1>

Parameters <NR1> point index

Returned Parameters <NR1> Resistance level for the specified point.

[SOURce:]STEP:RESistance:STATe

This command specifies how to process the STEP sequencing. The following parameters may be

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 73 74

Comentarios a estos manuales

Sin comentarios

Ametek PLA-PLW Programming Manual Manual de usuario Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Ametek PLA-PLW Programming Manual