Ametek PLA-PLW Programming Manual Manual de usuario descargar pdf (Pagina 40)

Command Syntax RESistance:SLEW:NEGative <NRf+>

Parameters slew time value, refer to model specifications | MIN | MAX

Unit ms

Query Syntax RESistance:SLEW:NEG?

RESistance:SLEW:NEG? MIN RES:SLEW:NEG? MAX

Returned Parameters <NRf+>

[SOURce:]RESistance:SLEW:POSitive

This command sets the slew time of the resistance for positive going transitions. MINimum sets the

slew to the fastest possible time. MAXimum sets the slew to the slowest time.

Command Syntax RESistance:SLEW <NRf+>

RESistance:SLEW:POSitive <NRf+>

Parameters Refer to model specifications | MIN | MAX

Unit ms (milli-second)

Query Syntax RESistance:SLEW?

RESistance:SLEW? MIN

RES ista nce:S LEW? MAX

RESistance:SLEW:POSitive?

RESistance:SLEW:POSitive? MIN

RESistance:SLEW:POSitive? MAX

Returned Parameters <NRf+>

[SOURce:]RESistance:TLEVel, RTR

Channel-Specific Resistance Command/Query. This command specifies the value of the

programmed resistance level for the TRANsient input when the electronic load is in the CR Mode.

When the Transient Subsystem is on, the electronic load input resistance will switch (under control of

the Transient Subsystem) between the main level and TLEVel at a ra te determined by the present

value of SLEW.

In order for the input resistance level to switch, TLEVel must be set to a value greater than the main

level. If TLEVel is set to a value below the main level, no error is generate

d but s

witching will not

occur until the main level is subsequently below the value of TLEVel.

Command Syntax RESistance:TLEVel <NRf+>

RTR <NRf+>

Parameters resistance transient level setting, refer to individual model specification |

MIN | MAX

Query Syntax RESistance:TLEVel?

RESistance:TLEVel? MIN RESistance:TLEV? MAX

RTR?

RTR? MIN RTR? MAX

Returned Parameters <NRf+> RES:TLEV? ret

urns the tr

ansient resistance level.

If the electronic load is not in CR Mode, the level will still be set, even if it

is less than the presently programmed input level.

[SOURce:]RESistance:[TRANsient:]TWIDth

This command sets the pulse width of the transients when the generator is in PULSe mode.

Note: This command will also change the RES:FREQ value.

Command Syntax RESistance:TRANsient:TWIDth <NRf+>

RESistance:TWIDth <NRf+>

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 73 74

Comentarios a estos manuales

Sin comentarios

Ametek PLA-PLW Programming Manual Manual de usuario Pagina 40

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Ametek PLA-PLW Programming Manual