Ametek ReFlex Programming Manual Manual de usuario Pagina 57

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 134
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 56
M380056-03 Rev M 53
3.
DC MODULE REMOTE PROGRAMMING
3.1
INTRODUCTION
This section covers the remote programming of the ReFlex Power™
programmable DC power supplies, High Power DC (HPDC) and Low Power DC
(LPDC). This interface enables operation of the HPDC and LPDC power supplies
from a computer via the Ethernet, allowing full remote programming control and
monitoring of the power supply.
The syntax of all SCPI commands implemented by the ReFlex Power™ system
and documented in this manual, are either SCPI confirmed in the SCPI 1999.0
Specification, Volume 2: Command Reference, or they are customized
commands not part of the SCPI definition, but conform to SCPI syntax.
3.2
FEATURES AND FUNCTIONS
F
EATURES
16-bit programming and 16-bit readback of voltage and current
Programmable over/undervoltage protection with reset
Programmable overcurrent protection
User selectable Constant-Voltage/Constant-Current mode, with reset
Field-upgradeable firmware via Ethernet
Soft calibration
P
ROGRAMMABLE
F
UNCTIONS
Output voltage and current
Soft limits for voltage and current
Over/Undervoltage protection
Programmable Overcurrent trip point
Output enable/disable
Maskable fault interrupt
Full calibration
Vista de pagina 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 133 134

Comentarios a estos manuales

Sin comentarios