Ametek ReFlex Programming Manual Manual de usuario descargar pdf (Pagina 113)

AC Module Remote Programming ReFlex Power™ Programming Manual

M380056-03 Rev L 109

Set a different voltage for each member of the phase group:

SOUR12:VOLT 110 // Set AC module in slot 12 to 110 volts

SOUR8:VOLT 90 // Set AC module in slot 8 to 90 volts

*OPC12? // Send next command after a ‘0’ is returned

*OPC8? // Send next command after a ‘0’ is returned

SOUR4:VOLT 75 // Set AC master module in slot 4 to 75 volts and

execute synchronous voltage change on all three

units

*OPC4? // Send next command after a ‘1’ is returned

… // Place other commands here

SYST:GROUP:DELETE 1004 // Delete 1004 group

SYST:GROUP:DELETE:ALL // Delete all groups

4.12.2 E

XAMPLE CREATING A

ARALLEL

ROUP

Create a Parallel group using three AC modules (units at slot 4, 8,12)

SYSTem:GROup:DEFine:PARallel 4,8,12 // Create the parallel group

SYSTem:GROup:CAT:PAR? // Query the group

OUTP1004:STATE 1 // Turn on all the units of the group

*OPC1004? // Send next command after a ‘1’ is returned

SOUR1004:VOLT 120 // Set the group to 120 volts

*OPC1004? // Send next command after a ‘1’ is returned

SOUR1004:CURR 20 // Each module may supply a maximum of 7.14 Amps. In

parallel group, the maximum current for the group is the

number of group members * the maximum current. (Refer

to specifications for high range and low range current.

*OPC1004? // Send next command after a ‘1’ is returned

… // Place other commands here

SYST:GROUP:DELETE 1004 // Delete 1004 group

SYST:GROUP:DELETE:ALL // Delete all groups

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 133 134

Sin comentarios

Ametek ReFlex Programming Manual Manual de usuario Pagina 113