Ametek BPS Series Programming Manual Manual de usuario descargar pdf (Pagina 183)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power

Manual P/N 7003-961 Rev. AA 183

IEC413:SWEep:LEVel

This command will set the level for the harmonics sweep test. The command will accept

either one parameter or five parameters. In case of one parameter, the level will be set for

the selected range only. The IEC413:STATe must be in the off position and the user class is

selected to accept the command.

Command Syntax IEC413:SWEep:LEVel <NRf>[,<NRf1.. NRf4]>

Parameters 0 to 20%

Examples IEC413:SWE:LEVel 10

Query Syntax IEC413:SWE:LEVel?

Returned Parameters <NR2>

IEC413:SWEep:DWELl

This command will set the dwell time in seconds for the entire sweep range. The class must

be selected prior to this command. Query with min and max to find the range of dwell time.

Command Syntax IEC413:SWEep:DWELl <NRf+>

Parameters <nrf>

Examples IEC413:SWE:DWEL 200

Query Syntax IEC413:SWE:DWEL?

Returned Parameters <NR1>

IEC413:SWEep:CURRent[:DATA]?

This command will return the measured harmonic current. This data is available after the

sweep is completed.

Command Syntax IEC413:SWEep:CURRent[:DATA] ]?

Parameters none

Query Syntax IEC413:SWE:CURR?

Returned Parameters <NR2>,.... ,<NRn>

IEC413:SWEep:FREQuency[:DATA]?

This command will return the frequency data points that correspond to the harmonic current

data points. This data is available after the sweep is completed.

Command Syntax IEC413:SWEep:FREQuency?

Parameters none

Query Syntax IEC413:SWE:CURR:FREQ?

Returned Parameters <NR2>,.... ,<NRn>

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 225 226

Sin comentarios

Ametek BPS Series Programming Manual Manual de usuario Pagina 183