Ametek BPS Series Programming Manual Manual de usuario descargar pdf (Pagina 136)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual

136 Manual P/N 7003-961 Rev AA

5.7 *PSC

This command controls the automatic clearing at power-on of the Service Request Enable

and the Standard Event Status Enable registers (see chapter 7 under 7.6.2 for register

details):

*PSC ON | 1 Prevents the register contents from being saved causing them to be

cleared at power-on. This prevents a PON event from generating a

SRQ at power-on.

PSC OFF | 0 Saves the contents of the Standard Event Enable and Service

Request Enable registers in nonvolatile memory and recalls them at

power-on. This allows a PON event to generate SRQ at power-on.

Using the PCS command in this mode allows the control program to

detect a power failure condition that caused the source to power down

and back up again.

Command Syntax *PSC<bool>

Parameters 0 | 1 | OFF | ON

Example *PSC 0 *PSC 1

Query Syntax *PSC?

Returned Parameters 0 | 1

Related Commands *ESE *SRE

5.8 *RCL

This command restores the AC/DC source to a state that was previously stored in memory

(including the transient list) with a *SAV command to the specified location. All states are

recalled with the following exceptions:

· CAL:STATe is set to OFF

· The trigger system is set to the Idle state by an implied ABORt command (this cancels

any uncompleted trigger actions)

Command Syntax *RCL <NRf>

Parameters 0 through 7

Example *RCL 3

Related Commands *RST *SAV

WARNING: Recalling a previously stored state may place hazardous voltages at

the AC source output.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 225 226

Sin comentarios

Ametek BPS Series Programming Manual Manual de usuario Pagina 136