Ametek DLM 600W Series Programming Manual Manual de usuario descargar pdf (Pagina 20)

Isolated Remote Analog Interface Operation DLM 600W Series

2-8 M51A Option

2.4.1 Voltage Source Programming of Output Voltage

Setting up for voltage source programming of the output voltage is as follows:

1. Set Position-1, V, of the INTFC SETUP switch to OFF (down) for 0-5VDC programming

range.

2. Set Position-1, V, of the INTFC SETUP switch ON (up) for 0-10VDC programming

range.

3. Connect the external programming voltage source to the ISOLATED ANALOG

INTERFACE connector, with positive to Pin-9 and negative to Pin-12.

4. Program the other parameters to the desired limit values: CURRENT PROGRAMMING

INPUT, Pin-10, and the OVP PROGRAMMING INPUT, Pin-3, with respect to pin-12.

5. Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG INTERFACE

connector to Pin-15.

2.4.2 Voltage Source Programming of Output Current

Setting up for voltage source programming of the output current is as follows:

1. Set Position-2, I, of the INTFC SETUP switch to OFF (down) for 0-5VDC programming

range.

2. Set Position-2, I, of the INTFC SETUP switch ON (up) for 0-10VDC programming range.

3. Connect the external programming voltage source to the ISOLATED ANALOG

INTERFACE connector, with positive to Pin-10 and negative to Pin-12.

4. Program the other parameters to the desired limit values: VOLTAGE PROGRAMMING

INPUT, Pin-10, and the OVP PROGRAMMING INPUT, Pin-3, with respect to pin-12.

5. Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG INTERFACE

connector to Pin-15.

2.4.3 Voltage Source Programming of OVP

Setting up for voltage source programming of OVP is as follows:

1. Set Position-3, OVP, of the INTFC SETUP switch to OFF (down) for 0-5VDC

programming range.

2. Set Position-3, OVP, of the INTFC SETUP switch ON (up) for 0-10VDC programming

range.

3. Connect the external programming voltage source to the ISOLATED ANALOG

INTERFACE connector, with positive to Pin-3 and negative to Pin-12.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Ametek DLM 600W Series Programming Manual Manual de usuario Pagina 20