Ametek CW Series Programming Manual Manual de usuario descargar pdf (Pagina 13)

SCPI Commands Elgar CW-P Series

3-4 Programming Manual

3.5 STATUS Commands

:STATus

The status commands tree.

:OPERation?

SCPI commands returns „1‟.

:OPERation

The SCPI Operation sub-tree.

:[EVENt?]

Returns „1‟.

:CONDition?

Returns „1‟.

:ENABle <value>

Sets the value in the Operations Enable register.

:ENABle?

Returns the value in the Operations Enable register.

:PRESet

Set the value of the Operations Enable register.

:QUEStionable?

Returns „1‟.

:QUEStionable

:CONDition?

Returns „1‟.

[:EVENt?]

Returns „1‟.

:ENABle <value>

Set the value of the Operations Enable register.

:ENABle?

Returns the value of the Operations Enable register.

3.6 SYSTEM Commands

:SYSTem

The system command tree.

:KLOCK?

Returns „1‟ if the front panel programmable

keys are locked out.

:KLOCK <boolean>

„1‟ locks the front panel programmable keys.

:CHECKSUM?

Returns the results of the checksum test.

1 = the checksum passed, 0 = failed.

:CHECKSUM

Specify that the CW shall re-check its flash

checksum.

:COMMunicate

The communications sub-tree.

:GPIB

The GPIB communications channel.

[:SELF]

SCPI sub-command.

:ADDRess <value> [<value>]

Set the GPIB address to a value of 1..31.

:ADDRess?

Returns the GPIB address presently set.

:AUTORUN <value>

„1‟ (ON) specifies the CW will automatically

close the output relay at power-up. „0‟ (OFF)

specifies the CW will power up in standby.

:AUTORUN?

Returns the state of the autorun parameter,

either „0‟ or „1.‟

:STORe <value>

Specify that the present system setpoint/

<value> address. <value> shall be 0..98.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

Comentarios a estos manuales

Sin comentarios

Ametek CW Series Programming Manual Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Ametek CW Series Programming Manual