Ametek 1995A Micro-Set PLS Manual de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 38
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
Chapter 7: Remote Circular Display
Installation and Maintenance Manual
22
Chapter 7: Remote Circular Display
NOTE: When using a remote circular display, the maximum number of outputs is limited to 24 outputs
or three expansion boards.
The Remote Circular Display (1995-1446) is ideal for mechanical stamping presses and shears.
Either position or RPM can be displayed on the large 3/4 LED digital display. A 360° bar graph will
increment in 10° intervals showing the angle of the resolver.
The remote circular display gets its RS422 synchronous signal from the four-place terminal strip located
on the back of the 1995 programmer. The display can be located up to 1,000 feet away from the
programmer. See Fig 11-2, Chapter 11: Wiring Diagrams.
Installation and wiring of the remote circular display should be followed in the same manner as the
1995A described earlier in Chapter 2.
7.1: POS/RPM On Remote Circular Display
The 3/4 LED display can display either position or RPM while the bar graph will always show angular
position. To display RPM install a jumper wire from Pin 6 (RPM) to Pin 7 (GND) on the 11-place
connector located on the bottom of the remote circular display.
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Comentarios a estos manuales

Sin comentarios