Ametek 1995A Micro-Set PLS Manual de usuario descargar pdf (Pagina 16)

Chapter 3: Programming

Installation and Maintenance Manual

Programming Reset-to-Preset Value

The Reset-to-Preset Value is programmed by entering the following:

A) Unit must be in the Program mode.

B) The Reset-to-Preset must first be enabled before you can store any values. To accomplish this,

depress . A zero (0) disables a

ENT

CIR#

6 6

(0 or 1)

ENT

function and a one (1) enables it.

C) Once the Reset-to-Preset has been enabled, you can store a value in memory. This is accom-

plished by depressing

ENT

CIR#

6 0

(Desired Reset Value)

ENT

NOTE: Valid numbers for CIR# 160 are zero (0) through the programmed scale factor, less one (1).

3.14: Motion Detector

A programmable Motion Detect output will energize a relay when the transducer speed exceeds the

customers preprogrammed RPM value.

The motion detector is set by entering the following:

A) Unit must be in the Program mode.

B) The motion detect must first be enabled before you can store any values. To accomplish this,

depress . A one (1) will enable the motion

ENT

CIR#

(0 or 1)

ENT

detect output circuit, and LS6 will now be your motion detect output relay. If a zero (0) is

entered, the motion detect feature is disabled and LS6 will function as a normal limit switch.

C) To set the value at which the motion detect relay energizes, depress

ENT

CIR#

7 6

(RPM Value)

ENT

NOTE: A CIR #176 can only be entered if the motion detect option is enabled.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Sin comentarios

Ametek 1995A Micro-Set PLS Manual de usuario Pagina 16