Ametek XBT Series Installation Manual de usuario descargar pdf

Technical Note

XBT Rackmount Installation

Document No. M370187-05 Rev A • 7/3/2008

PURPOSE

Provide instructions for assembling XBT rackmount kits.

PARTS

• rackmount piece

• filler panel

• M3.0 (3mm) screws (2 per benchtop unit; 3 per filler panel)

• M5.0 (5mm) screws (4 per rackmount)

TOOLS

Philips head screwdriver (not supplied with kit)

SUMMARY OF PROCEDURES

Remove feet from benchtop unit; attach rackmount parts (rackmount piece and filler panel if installing single unit), and insert and

secure to rack. See Figure 10 and Figure 11, for dimensions drawings in last section of this document.

Assembled Rackmounts: Single (Figure 1) and Duo (Figure 2).

Figure 1. Rackmount with Single Unit and Filler Panel Figure 2. Rackmount with Two Units

PROCEDURES

1. On an appropriate work surface (flat and sturdy), place unit with bottom face up.

2. Remove rubber pads from each of four feet.

Unscrew and remove four feet. (Recommend keeping together rubber pads, screws and feet in event that

unit is ever needed for benchtop use).

4. With unit still in bottom-up position, lay rackmount piece on unit with its front lip overhanging front of unit and

one side (right or left) flush against same (corresponding) side of unit, and with screw holes on rackmount

piece aligned with holes where feet were removed from unit (

Figure 3).

9250 Brown Deer Road, San Diego CA 92121 • Tel: 858-450-0085 • Fax: 858-458-0267 • email: sales@programmablepower.com • Web: www.programmablepower.com

1 of 6

1 2 3 4 5 6

Technical Note 1

Indice de contenidos

Pagina 1 - Technical Note

Technical Note XBT Rackmount Installation Document No. M370187-05 Rev A • 7/3/2008 PURPOSE Provide instructions for assembling XBT rackmount kits.

Pagina 2

Technical Note XBT Rackmount Installation Document No. M370187-05 Rev A • 7/3/2008 Figure 3. Unit, Bottom Up, with Main Rackmount Piece Aligned

Pagina 3

Technical Note XBT Rackmount Installation Document No. M370187-05 Rev A • 7/3/2008 Figure 5. Filler Panel Figure 6. Filler Panel Placement

Pagina 4

Technical Note XBT Rackmount Installation Document No. M370187-05 Rev A • 7/3/2008 9. Align screw holes at bottom of filler panel with screw hole

Pagina 5

Technical Note XBT Rackmount Installation Document No. M370187-05 Rev A • 7/3/2008 Figure 9. Screw Holes for Securing Assembly to Rack 13. Use

Pagina 6

Comentarios a estos manuales

Sin comentarios

Ametek XBT Series Installation Manual de usuario

Busca en linea o descarga Manual de usuario para Equipo Ametek XBT Series Installation. AMETEK XBT Series Installation User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Ametek XBT Series Installation